NEC MultiSync P243W User Manual page 26

TagA ROTATION
DDC/CI
SCREEN SAVER*
BLANK SIGNAL SKIP Skips no signal inputs when you change input signal with INPUT button.
INPUT SETTING*
(Analog input only)
ANALOG DETECT
TagB CARBON SAVINGS
CARBON USAGE
COST SAVINGS
CARBON CONVERT
SETTING
CURRENCY
SETTING*
1
* 1 This item does not reset by FACTORY PRESET (Tag7).
OSD:
AUTO: The OSD rotates automatically when the monitor is rotated. OSD ROTATION is
set to AUTO by default.
LANDSCAPE: Display the OSD with landscape mode.
PORTRAIT: Display the OSD with portrait mode.
PICTURE1:
AUTO: The left/up side or main window image automatically rotates according to the
orientation of the display.
OFF: The window image is not rotated.
ON: The left/up side or main window image always rotated.
NOTE: Interlace signal does not rotate. When MULTI PICTURE is set to OFF then
PICTURE1 is set to ON or AUTO, the displayed image will rotate.
PICTURE2 (MULTI PICTURE ON only):
AUTO: The right/down side or sub window image automatically rotates according to
the orientation of the display.
OFF: The window image is not rotated.
ON: The right/down side or sub window image always rotated.
NOTE: Interlace signal does not rotate. When MULTI PICTURE is set to OFF,
PICTURE2 is not available.
DDC/CI ENABLE/DISABLE: Turns on or off the two way communication and control with
connected PC by the video cable.
Use the SCREEN SAVER to reduce the risk of image persistence.
1
NOTE: SCREEN SAVER works when MULTI PICTURE is OFF. SCREEN SAVER works
when ENABLE is OFF in TILE MATRIX.
MOTION (Default OFF): Screen image moves periodically in 4 directions in order to
reduce the risk of image retention.
Timing for MOTION can be set so the screen image moves in intervals from every
10 to 900 seconds. Timing is set in 10-second increments.
OPTION (Default REDUCED): There are two optional selections.
REDUCED: Screen image is reduced to 95% size and is moved periodically in
4 directions. Screen may appear slightly less sharp than normal. The full image
appears on the display.
NOTE: Some input signals may not be supported by REDUCED.
FULL: Screen image is set to FULL and is moved periodically in 4 directions. Screen
image goes outside of the display area in the direction that it shifts so that a portion of
the image may appear to be cut off.
Video Band Width: Reduces the visual "noise" level of the input signal. The higher the
1
number, the greater the effect of reducing the noise. Press "LEFT" or "RIGHT" to select.
Clamp position: Operating your monitor at a non-standard timing may cause images to
appear darker than normal or have color distortion. Use of the Clamp position control will
adjust images to their normal state.
Selects a type of analog input sync signal.
SEP/COMP: Please select this setting if you input horizontal and vertical sync signal
separately from a video input.
SOG: Please select this setting if you input an input with horizontal and vertical sync
signal.
NOTE: It might not be displayed properly if sync signal input and the selection you made
at this setting are not matched.
Displays the estimated carbon savings information in kg.
Displays the estimated carbon usages information in kg. This is the arithmetic estimation,
not actual measurement value. This estimation is based without any options.
Displays the electricity cost savings in balance.
Adjusts the carbon footprint factor in the carbon saving calculation. This initial setting is
based on the OECD data (2008 Edition).
Displays electricity pricing (available in 6 currency units).
English-24