NEC MultiSync P243W User Manual page 23

Tag5 H.POSITION
V.POSITION
H.SIZE
(Analog input only)
FINE
(Analog input only)
H.RESOLUTION
V.RESOLUTION
EXPANSION
OVER SCAN
(HDMI input only)
SIDE BORDER
COLOR
Tag6 USB SELECT
VIDEO DETECT*
* This item does not reset by FACTORY PRESET (Tag7).
1
Controls Horizontal Image Position within the display area of the LCD.
Press "LEFT" or "RIGHT" to adjust.
Controls Vertical Image Position within the display area of the LCD.
Press "LEFT" or "RIGHT" to adjust.
Adjusts the horizontal size of the screen.
If the "AUTO ADJUST" function does not give you a satisfactory picture setting, a further
tuning can be performed by using the "H.SIZE (V.SIZE)" function (dot clock). A Moiré test
pattern can be used for this. This function may alter the width of the picture. Use LEFT/
RIGHT Menu to center the image on the screen. If the H.SIZE (V.SIZE) is incorrectly
calibrated, vertical bands will appear. The image should be homogeneous.
Improves focus, clarity and image stability by increasing or decreasing this setting.
If the "AUTO ADJUST" function and the "H.SIZE" function do not give you a satisfactory
picture setting, fine tuning can be performed by using the "FINE" function. A Moiré test
pattern could be used for this. If the Fine value is incorrectly calibrated, horizontal lines
will appear on the display. The image should be homogeneous.
Adjusts the horizontal size by increasing or decreasing the setting.
Press "RIGHT" button to expand the width of the image on the screen.
Press "LEFT" button to narrow the width of the image on the screen.
Adjusts the vertical size by increasing or decreasing the setting.
Press "RIGHT" button to expand the height of the image on the screen.
Press "LEFT" button to narrow the height of the image on the screen.
Sets the zoom method.
FULL: The image is expanded to full screen, regardless of the resolution.
ASPECT: The image is expanded without changing the aspect ratio.
OFF: The image is not expanded.
Some video formats may require different scanning modes in order to best display the image.
ON: Image size is larger than what can be displayed. The image edge will appear
cropped. Approximately 95% of the image will be shown on the screen.
OFF: Image size stays within the display area. The whole image is displayed on the screen.
AUTO: Auto setting.
Adjusts the side black bars color between black and white.
USB upstream port selection for DP/HDMI/DVI-D/D-SUB. When connecting a computer
to each of the upstream ports, the monitor's USB downstream ports can be used by
selecting this setting for the current input signal. When using only one upstream port, the
connected upstream port is active.
You can change the active display and upstream USB port combination by using the
Input button (see page 11).
NOTE: To avoid data loss, before changing USB upstream ports, ensure that no USB
storage devices are in use by the operating system of the computer attached to the USB
upstream port.
Selects the method of video detection when more than one computer is connected for
1
active picture.
Press "LEFT" or "RIGHT" to select.
FIRST: When the current video input signal is not present, then the monitor searches for
a video signal from the other video input port(s). If the video signal is present in another
port, then the monitor switches the video source input to the detected video source
automatically. The monitor will not look for other video signals while the current video
source is present.
LAST: When the monitor is displaying a signal from the current source and a new
secondary source is supplied to the monitor, then the monitor will automatically switch to
the new video source. When current video input signal is not present, then the monitor
searches for a video signal from the other video input port(s). If the video signal is
present in another port, then the monitor switches the video source input port to the new
found video source automatically.
NONE: The video input signal detection is not enabled.
English-21