Reset Button; Antennas And Installation Scenarios - Cisco IR829 Hardware Installation Manual

Product Overview
SKU
IR829GW-LTE-NA-AK9
IR829GW-LTE-VZ-AK9
IR829GW-LTE-GA-EK9
IR829GW-LTE-GA-ZK9

Reset Button

The Reset button resets the router configuration to the default configuration set by the factory. To restore the
router configuration to the default configuration set by the factory, use a standard size #1 paper clip with wire
gauge 0.033 inch or smaller and simultaneously press the reset button while applying power to the router.
NOTE: The rear cover must be removed to expose the reset switch.
NOTE: Before performing a write erase and reboot on the IR829, review the details in the
Integrated Services Router Software Configuration Guide.
Antennas
The IR829 has RP-TNC connectors for Wi-Fi and TNC connectors for cellular. The IR829 also has an SMA
connector for a GPS antenna.
Standard antennas are:
• Two multiband swivel-mount dipole antennae (ANT-4G-DP-IN-TNC) and one extender (4G-AE010-R).
• WLAN: Three Cisco Multiband Swivel-Mount Dipole Antennae. (AIR-ANTM2050D-R) for WLAN
For detailed information about Cisco Antennas, please refer to the following guides:
Cisco Industrial Routers Antenna Guide:
http://www.cisco.com/c/en/us/td/docs/routers/connectedgrid/antennas/installing-combined/industrial-routers-antenna-guide.html
Cisco Aironet Antennas and Accessories Reference Guide
http://www.cisco.com/c/en/us/products/collateral/wireless/aironet-antennas-accessories/product_data_sheet09186a008008883b.html

Antennas and Installation Scenarios

NOTE: Before choosing your antenna type and installation scenario, read through the following information.
Coexistence of radio standards:
When operating and planning installation of products with WiFi, 4G LTE, and GPS wireless standards
coexisting on the IR829 platform, the user needs to provision greater than 15dB isolation between the WiFi
and LTE antennas at all frequencies of 4G LTE and WiFI operation for minimum impact to performance.
Ideally, isolation should be 20-25dB or more. Specifically, users should not install 4G LTE dipoles and WiFi
dipoles on the chassis at the same time, since doing so would generally result in less than 15dB isolation and
may have a strong impact on performance depending on frequency bands in question.
Country Wi-Fi
Domain
North America A
North America A
Global E
Australia A
functionality.
Cisco IR829 Industrial Integrated Services Router Hardware Installation Guide
Cellular Carrier
AT&T
Verizon
Global
Australia
The IR829 differs from traditional IOS routers.
Reset Button
Cisco IR800
19