Cisco IR829 Hardware Installation Manual page 35

Product Overview
Type of SFP Module
Extended Temperature SFP
23° to 185°F (-5° to 85°C)
Copper SFP
Supported on IOS 15.6(3)M but GE only
NOTE: The WAN port GE0 can accept either fiber SFP or Copper SFP modules. The speed is fixed at
100Mbps or 1Gbps depending on the SFP installed. Since there is no I-temp copper SFP available in the
market, there is no Copper SFP supported. In order to use a Copper SFP, you must enter service internal mode,
and enter "unsupported transceivers". Then unplug and insert the Copper SFP again.
NOTE: Speed and duplex commands are not available on the GE0 WAN interface.
The following two Copper SFPs (non I-temp) will be officially supported at 1Gbps:
• Copper SFP - GLC- T
• Copper SFP - SFP-GE-T
Additional SFPs with added support are:
• GLC-FE-100LX-RGD
• GLC-FE-100FX-RGD
• GLC-TE
• GLC-FE-T=
NOTE: Auto negotiation is not supported on these SFPs.
For minimum software requirements, refer to the Release Notes for your platform.
• Copper 1Gbps, (0 to 70°C), CPN is 30-1410-04
• Copper 1Gbps, (-5 to 85°C), CPN is 30-1421-02
• Fiber (fixed speed of 100Mbps)
• Fiber (fixed speed of 100Mbps)
• Copper (fixed speed of 1Gbps)
• Copper 100Mbps
Cisco IR829 Industrial Integrated Services Router Hardware Installation Guide
Model
SFP-GE-S, with Digital Optical Monitoring (DOM) support
SFP-GE-L, with Digital Optical Monitoring (DOM) support
SFP-GE-Z, with Digital Optical Monitoring (DOM) support
GLC-SX-SMD
GLC-LH-SMD
GLC-EX-SMD
GLC-TE
GLC-FE-100LX-RGD
GLC-FE-100FX-RGD
GLC- T (0 to 70°C)
SFP-GE-T (-5 to 85°C)
SFP Modules
33