Husqvarna Vitpilen 401 2018 Owner's Manual page 170

15 WHEELS, TIRES
168
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the rear wheel bearing.
–
Clean and grease shaft seal rings
A
surfaces
Long-life grease (
–
Clean the thread of the wheel spindle and axle nut.
–
Clean and grease the wheel spindle.
E01131-10
Long-life grease (
–
Clean the contact areas of the brake caliper support and
swingarm.
–
Mount the rubber damper and rear sprocket carrier on the
rear wheel.
–
Insert the narrow spacer into the side of the rear sprocket.
–
Insert the wide spacer into the side of the brake disc.
–
Position the rear wheel.
The brake linings are correctly positioned.
–
Push the rear wheel forward as far as possible and lay the
chain on the rear sprocket.
–
Position the chain guard.
1
and contact
of the spacers.
p. 249)
p. 249)