Barco ClickShare CS-100 Installation Manual page 85

Problem
Video is not shown on screen
Some programs of Windows are
not shown on the display
When using Windows 7 the
following message about the
Windows Aero color scheme
appears: "Windows has detected
your computer's performance is
slow. This could be because there
are not enough resources to run
the Windows Aero color scheme.
To improve...".
Your screen is not shown on the
display when pressing the Button
Your content is removed from the
display and the LEDs on the button
are blinking white
Nothing is shown on the displays
at all.
Bad WiFi connectivity
Cause
Player uses overlays
Use of overlays, 3D or hardware
acceleration in the GPU
ClickShare uses resources from
the GPU. In combination with
other programs which do so,
Windows 7 sometimes shows this
message suggesting to disable
Aero to improve the performance
of your laptop.
You are the second person that
wants to share content. Only one
screen can appear simultaneously
The ClickShare software is not
running.
Connection to the Base Unit is
lost.
The displays are switched off.
The display cable is not correctly
connected
The display does not recognize or
is not able to display the Base Unit
output resolution.
The Base Unit is in standby mode
Congestion of the wireless
channel
Metal cabinets, walls, construction
elements, ... can cause reflections
deteriorating the wireless signal.
Obstructions between Buttons and
Base Unit cause lowering of the
wireless strength and quality.
Troubleshooting
Solution
Disable the usage of overlays in
the preferences of the video
player.
• Disable overlays or hardware
acceleration in the GPU.
• Disable AeroGlass in Windows
7
• Upgrade the Base Unit to the
latest software version.
It is safe to ignore this message
and choose 'Keep the current
color scheme'.
Click and hold the button for 2
seconds to use the Show me full
screen function.
Go to the ClickShare drive and run
the software.
ClickShare tries to restore the
connection automatically. If it fails,
the LEDs on the Button start
blinking red.
Unplug the button from your laptop
and try a new button.
Switch on the displays.
Insert the display cable to the
display and the Base Unit.
Change the corresponding setting
via the web interface.
Briefly push the standby button on
the Base Unit or insert a button
and run the ClickShare software.
Use wireless network scan tools to
look for free or the least congested
channels.
Move the Base Unit to another
place in the room.
Avoid placing it inside cabinets,
false ceiling, below the table,
behind a wall, in another room, ....
R5900022-09 ClickShare CS-100 85