Energy Savers - Barco ClickShare CS-100 Installation Manual

CS-100 Configurator

6.18 Energy savers

About standby
Standby after (minutes): If there is no client connection detected during the standby timeout period, the Base
Unit will enter the selected standby mode.
Default setting: Time to standby: 10 min, the Base Unit will enter the Eco standby mode.
Eco standby
When the Base Unit enters ECO standby mode, it will disable the HDMI output signal and go in low power
mode. The Base Unit's LEDs will be breathing white to indicate the ECO standby mode.
Power consumption in Eco standby: 2.6W
The Base Unit will wake up with one of the following actions:
• Button or app connecting with the Base Unit
• Press the standby button on the Base Unit
• "Wake up" signal over the network
• Pairing a Button on the Base Unit's USB port
• Detection of display hot plug
Deep standby
When the Base Unit goes in Deep standby mode, it will shut down all processes, including the Wi-Fi access
point and the (secondary) LAN connection.
For devices with two LAN interfaces (e.g. CSE-800), when there is an active network connected to the primary
LAN connection and Corporate network is enabled, the primary LAN interface will remain active and the Base
Unit's LEDs will be breathing white to indicate this standby mode. Otherwise, The Base Unit's LEDs will be
dark.
Power consumption in Deep standby: 0.4W
The Base Unit will wake up when the standby button on the Base Unit is pressed, or
when the primary LAN interface remains active, a detection of HDMI input hot plug or button or app connecting
with the Base Unit's primary LAN interface.
Image 6-28: Energy savers
74 R5900022-09 ClickShare CS-100