To Mount The Node To A Valve (Figure 1); Mounting The Node; Connecting A Weather Sensor - Hunter Node Owner's Manual

MOUNTING THE NODE

The NODE can easily be mounted on any Hunter plastic valve .
A specially designed valve mounting clip makes installation a
snap . A protective rubber cover is provided to prevent dirt from
accumulating on the face of the NODE .

To Mount the NODE to a Valve (Figure 1)

1 . Unscrew the existing solenoid from the valve .
2 . Screw the Hunter DC latching solenoid (P/N 458200) into the
valve bonnet .
3 . Attach the large end of the valve mounting clip to the middle
of the NODE body .
4 . Snap the small end of the valve mounting clip to the solenoid .
Mounting Clip
Figure 1

CONNECTING A WEATHER SENSOR

A Hunter Mini-Clik ® or Rain-Clik
the NODE . The purpose of this sensor is to stop watering when
weather conditions dictate .
NOTE: When the Rain Sensor is interrupting the
watering, the display will show the System Off
icon , "OFF" and
1 . Cut the yellow wire loop attached to the NODE at
approximately the middle of the loop .
2 . Remove approximately ½" (13 mm) of insulation from each
wire . Attach one yellow wire to each of the wires of the weather
sensor . You can mount the rain sensor up to 100 ft (30 m) from
the NODE controller (18AWG/1 .0 mm minimum wire size) .
3 . Secure wire connections with waterproof connectors .
Hunter Model Mini-Clik
® rain sensor can be connected to
on the display.
®
6