Connecting The Battery/Batteries - Hunter Node Owner's Manual

CONNECTING THE BATTERY/BATTERIES

The NODE uses two standard 9-volt batteries (not included) to
operate the valves and program the controller . The controller can
operate using either a single 9-volt battery or using two 9-volt
batteries . Under normal conditions, the expected life is 1 year for a
single battery and two years when using two 9-volt batteries .
NOTE: The NODE has non-volatile memory
which allows for the battery to be removed
without losing program information.
To Install the Battery/Batteries
1 . Unscrew the rear body of the NODE body to gain access to
the battery compartment .
2 . Insert the battery/batteries into the battery tray and connect to
the controller using the battery connector .
3 . Make sure that no water is inside the battery compartment .
4 . Screw the NODE rear body back onto the front half .
NOTE: Make sure that the seal marker on the
rear half of the NODE lines up with the front
half, ensuring that a proper seal is created.
ENG
4