AquaProbe FEA100 / FEA200
Electromagnetic flowmeter – insertion-type flow sensors
4 Electrical Installation
4.1 Sensor Terminal Box Connections – WaterMaster FET100 Transmitter
Caution.
Make connections only as shown.
Remove foil screens
Twist the three screen wires together and sleeve them.
Twist cable pairs together
Maintain Environmental Protection at all times.
Conduit connections must provide cable entry sealing.
*Inner wire
Fig. 4.1 Cable Connections at Flow Sensor Terminal Block – WaterMaster FET1 Transmitter
20
4 Electrical Installation
S1 Violet (Screen)
E1 Violet (*Signal)
E2 Blue (*Signal)
S2 Blue (Screen)
Cut cables to
3 Green (Sleeve)
60 mm (2.35 in.)
D2 Yellow
D1 / TFE Orange
SCR (Screen)
M2 Red
M1 Brown
OI/FEA100/200–EN Rev. D