AquaProbe FEA100 / FEA200
Electromagnetic flowmeter – insertion-type flow sensors
3.6 Installing the Flow Sensor
Warning. When inserting or removing the flow sensor suitable restraining equipment must be used to
prevent the flow sensor being forced out under pressure. Ensure that the valve is fully open.
Dimensions in mm (in.)
Fig. 3.7 Insertion Bore Clearance
3
4
Fig. 3.8 Installing the Flow Sensor
OI/FEA100/200–EN Rev. D
25 (1) Minimum
Clearance
1
5
2
Referring to Fig. 3.8:
a Tighten the nut (hand-tight only).
b Remove the cap.
c Apply PTFE tape.
d Insert the flow sensor into the valve.
e Tighten firmly.
3 Mechanical Installation
15