Explanation Of The Application Range; Mounting Instructions - Klauke i-press mini MAP2L Instruction Manual

Instruction Manual
MAP2L

4.2 Explanation of the application range

The hand guided pressing tool is to mount fi ttings on multi Layer, copper and stainless steel type plumbing pipes with
Ø 12 to 28 mm, respectively 32 mm (multi layer pipes). The unit is not supposed to be restrained in a vise. It is not
allowed to use the tool in a stationary application.
The tool is not designed for continued pressing operations. After a sequence of approximately 50 completed com-
pressions you have to make a break of 15 min. to give the tool time to cool down.
Attention
Too intensive use can cause heat damages for the tool
Attention
During the operation of built-in electric motors sparks can occur which might ignite highly infl ammable or
explosive liquids and materials
Attention
Electric tools must not be operated in pouring rain or under water.

4.3 Mounting instructions

Please reference the assembly manual of the systems supplier before mounting the fi ttings on the pipes. In order to
safeguard a proper pressing and to guaranty a safe and reliable handling the machine must only be operated with
pressing jaws/dies recommended by the provider of the pipe system and/or the tool manufacturer. If the markings on
the tool and pressing jaw do not match respectively if there are no assembly instructions the user has to contact the
provider of the system to request a compatibility statement.
Attention
Do not use bent or damaged pressing jaws.
Remark
As a system supplier/tool manufacturer we offer perfectly designed pressing jaws for all pipe dimensions.
Special designs and customer solutions upon request.
HE.13112_A © 08/2009 6
GB