Explanation Of The Application Range - Klauke EK 35/4-L Instruction Manual

Instruction Manual Crimping Tool
EK 35/4-L
Attention
The crimping process can be interrupted at any moment by releasing the trigger.

4.2 Explanation of the application range

The tool has a large number of various dies available to crimp Klauke connecting material (Table 2).
Attention
Do only crimp those connecting materials mentioned in Table 2.
If different conducting materials have to be crimped, please contact the manufacturer.
Attention
Do not crimp on live cables or conductors. This tool is not considered an insulated tool.
The hand held tool is not supposed to be restrained in a vise. It is not allowed to use the tool in a stationary applica-
tion.
The tool is not designed for continued crimping operations. After a sequence of approximately 30-40 completed
crimps you have to make a break of 15 min. to give the tool time to cool down.
Attention
Too intensive use can cause heat damages for the tool
Attention
During the operation of electric engines sparks can occur which might ignite highly infl ammable or explosi-
ve liquids and materials
Attention
Electric-hydraulic crimping tools should not be operated in pouring rain or under water.
4.3 Mounting instructions
Please read the assembly instructions in our general catalogue.
Attention
Even if the code number is identical only those dies should be used which are suitable for the material.
HE.14064_B © 12/2010 5
GB