Signal Problems - ZyXEL Communications LTE3202-M430 User Manual

8.5.3.4 Encryption
Wireless networks can use encryption to protect the information that is sent in the wireless network.
Encryption is like a secret code. If you do not know the secret code, you cannot understand the
message.
The types of encryption you can choose depend on the type of authentication. (See
page 55 for information about this.)
Table 25 Types of Encryption for Each Type of Authentication
Weakest
Strongest
For example, if the wireless network has a RADIUS server, you can choose WPA or WPA2. If users do not
log in to the wireless network, you can choose no encryption, Static WEP, WPA-PSK, or WPA2-PSK.
Usually, you should set up the strongest encryption that every device in the wireless network supports. For
example, suppose you have a wireless network with the LTE3202-M430 and you do not have a RADIUS
server. Therefore, there is no authentication. Suppose the wireless network has two devices. Device A
only supports WEP, and device B supports WEP and WPA. Therefore, you should set up Static WEP in the
wireless network.
Note: It is recommended that wireless networks use WPA-PSK, WPA, or stronger encryption.
The other types of encryption are better than none at all, but it is still possible for
unauthorized wireless devices to figure out the original information pretty quickly.
When you select WPA2 or WPA2-PSK in your LTE3202-M430, you can also select an option (WPA
compatible) to support WPA as well. In this case, if some of the devices support WPA and some support
WPA2, you should set up WPA2-PSK or WPA2 (depending on the type of wireless network login) and
select the WPA compatible option in the LTE3202-M430.
Many types of encryption use a key to protect the information in the wireless network. The longer the
key, the stronger the encryption. Every device in the wireless network must have the same key.

8.5.4 Signal Problems

Because wireless networks are radio networks, their signals are subject to limitations of distance,
interference and absorption.
Problems with distance occur when the two radios are too far apart. Problems with interference occur
when other radio waves interrupt the data signal. Interference may come from other radio
transmissions, such as military or air traffic control communications, or from machines that are
coincidental emitters such as electric motors or microwaves. Problems with absorption occur when
physical objects (such as thick walls) are between the two radios, muffling the signal.
Chapter 8 WLAN
NO AUTHENTICATION
No Security
Static WEP
WPA-PSK
WPA2-PSK
LTE3202-M430 User's Guide
RADIUS SERVER
WPA
WPA2
56
Section 8.5.3.3 on