Table of Contents
Advertisement
D
D1
Introduction
Transport (i.e. transfer of the machine from one place
to another) and handling (i.e. transfer inside work-
places) must occur with the use of special equipment
of adequate capacity.
IMPORTANT!
Due to its size, during transport, han-
dling and storage one machine cannot
be stacked on top of another, therefore
possible risks of load overturning are
excluded.
The machine must only be transported, handled and
stored by qualified personnel, who must have:
-
specific technical training and experience;
-
knowledge of the safety regulations and applicable
laws in the relevant sectors;
-
knowledge of the general safety provisions;
-
the ability to recognize and avoid any possible haz-
ard.
D1.1
Transport: Instructions for the carrier
WARNING!
Do not stand under suspended loads
during the loading/unloading phases.
Unauthorized
access the work zone.
IMPORTANT!
The machine's weight alone is not suf-
ficient to keep it steady.
The transported load can shift:
-
when braking;
-
when accelerating;
-
in corners;
-
on particularly rough roads.
D2
Handling
Arrange a suitable area with flat floor for machine
unloading and storage operations.
D2.1
Procedures for handling operations
For correct and safe lifting operations:
•
use the type of equipment most suitable for charac-
teristics and capacity (e.g. lift trucks or electric pal-
let truck);
•
cover sharp edges;
•
check the forks and lifting procedures according to
the instructions given on the packing.
Before lifting:
•
send all operators to a safe position and prevent
persons from accessing the handling zone;
•
make sure the load is stable;
•
make sure no material can fall during lifting, and
manoeuvre vertically in order to avoid impacts;
18
TRANSPORT, HANDLING AND STORAGE
personnel
must
•
handle the machine, keeping it at minimum height
from the ground.
CAUTION!
For machine lifting, do not use mova-
ble or weak parts such as casings,
electrical raceways, pneumatic parts,
etc., as anchoring points.
D2.2
Translation
The operator must:
•
have a general view of the path to be followed;
•
stop the manoeuvre in case of hazardous situa-
tions.
D2.3
Placing the load
Before placing the load make sure the path is free and
that the floor is flat and can take the load.
D3
Storage
The machine and/or its parts must be stored and
protected against damp, in a non-aggressive place
free of vibrations and with room temperature of
between -10°C / 14°F and 50°C / 122°F.
The place where the machine is stored must have a
flat support surface in order to avoid any twisting of the
machine or damage to the support feet.
not
IMPORTANT!
Machine positioning, installation and
disassembly must be carried out by a
specialized technician.
IMPORTANT!
Do not make modifications to the parts
supplied with the machine. Any miss-
ing or faulty parts must be replaced
with original parts.
Hide quick links:
Advertisement
Table of Contents
