Installation; Set Up And Operation - SHOWTEC Colorburst V1 Manual

Colorburst

Installation

Remove all packing materials from the Colorburst. Check if all foam and plastic padding is removed.
Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply. The device can be sound-controlled as it is equipped
with a built-in microphone.
The Interlock plug/remote plug and safety keys are included in the box.
The interlock is the "included-in-the-box" successor for the optional remote interlock (51316).
They should be kept with the Colorburst !!!
The following safety precautions should be followed:
● The remote control plug should be placed on the frontside (06)
of your Colorburst.
● The keys should be put into the lock (08) of your Colorburst.
Warning
If the plug is not connected, your laser will not function.
If the key is not set to ON, your laser will not function.
Ordercode: 43163
11
Fig. 03