Capture Shield Installation - Foxfury Lighting Solutions TAKER R40 Product Manual

CAPTURE SHIELD INSTALLATION

ADAPTOR
SHROUD
1
1. Drill two (2) holes in the riot shield using the included Drilling Template on
pg. 15.
2
2. Assemble the R40 light to the Adaptor Shroud AND the Capture Adaptor
then place the light against the INSIDE of the riot shield.
3
3. Use a Phillips head screwdriver and crescent wrench to install and secure
the R40 to the inside of the riot shield using the supplied hardware (M6
bolt, washers, and nuts).
NOTE: Be careful not to overtighten the bolts!
10
INCLUDED HARDWARE
M6 Bolts (2)
Bolts (2)
Washers (8)
Nuts (4)
CAPTURE ADAPTOR
CAPTURE SHIELD
Place the shield in
FRONT of the R40.
(The shield pictured is cut in
half for this visual)
FRONT OF SHIELD