Charging The Power Pack - Foxfury Lighting Solutions TAKER R40 Product Manual

CHARGING THE POWER PACK

1
3
1. 1 Press and hold the Power Pack Release Lever located on the Light Head
portion of the Taker R40.
2
2. While maintaining pressure on the Power Pack Release Lever, pull the Light
Head and the Power Pack apart.
If unable to pull apart easily (due to resistance of the internal rubber
gasket), try moving the Power Pack back and forth while pulling apart.
NOTE: Once apart, be sure to keep both ends dry and away from
water, moisture and dust. While the Power Pack and Light Head are
separated, the unit DOES NOT maintain its waterproof rating.
3. Insert the provided Micro USB Cable into the Power Pack— respect the
3
orientation/alignment. Then, insert the opposite end, USB (Type A) into a
USB compatible power source or into the included AC/DC Adaptor.
(Input: 100V–240VAC 50/60 Hz, Output: 5V DC 1000mAH).
The Charge Indicator will be solid red while charging. Once fully
charged, it will turn green.
Charging time will be approximately 2.5 hours.
After the Power Pack is charged, disconnect it from USB Cable.
IMPORTANT: The R40 in steps 1–3 is shown without the Adaptor Shroud and
is flipped to show the Power Pack Release Lever. The R40 does NOT need to
be removed from the Adaptor Shroud to change Power Packs.
2
5