Table of Contents
Advertisement
DRILLING TEMPLATE
FOR USE WITH THE TAKER R40 (P/N 700-331)
INSTRUCTIONS
INSTRUCTIONS:
Use this template to drill the required holes for mounting the Taker R40 to a
Use this template to drill the required holes for mounting
riot shield.
the Taker R40 to a Riot shield.
1.
Begin by cutting this sheet out and taping and centering it (or vertically
1
1. Begin by taping this sheet to the shield and centering it (or
aligning it to the desired location).
vertically aligning it to desired location).
2.
Drill two (2) pilot holes that are 50 mm apart using a
2. Drill two pilot holes that are 50mm apart using a
2
smallest circle (
(use the smallest circle (
3. Using the recommended
3.
Using the recommended
3
mm apart (approx 2 in).
holes that are 50mm apart (approx 2").
NOTE: Image above is to size and holes are 50mm apart.
NOTE: Image above is to size and holes are 50 mm apart.
DRILLING TEMPLATE
) as a guide to drill the pilot hole).
) as a guide to drill the pilot hole).
17
/
" or 7mm drill bit, drill two (2) holes that are 50
12
64
/
" or 7mm drill bit, drill two
64
/
1
/
" drill bit (use the
1
" drill bit
8
8
15
Advertisement
Table of Contents
