Table of Contents
Advertisement
MAINTENANCE
REPLACING THE O-RING (P/N 51-112)
1
1.
1
Separate the Power Pack from the Light Head (follow steps 1–2 in the
"Charging the Power Pack" section on page 5).
2.
Using a #2 Phillips head screwdriver (not included) remove the screw from
2
the Light Head (reference "Disassembled Light Head" diagram on page 3).
3.
3
The Retaining Tab and "O"-Ring can now be removed.
If the "O"-Ring does not fall out on its own when unscrewed, it may
need to be pulled out.
Examine the "O"-Ring for cracks. If cracks are found, a replacement
will be needed to ensure the R40 waterproof rating.
FOR REINSTALLATION, follow the above listed steps in reverse order. NOTE:
The "O"-Ring can be lubricated with a non-silicone based grease.
REMOVING THE GUARDS (P/N 51-905)
1
1.
1
Use a size T6 Star-Tip (TORX) driver or bit (not included) to take out the
screws on the top and bottom of the R40.
2.
Once screws are loose, remove them and then lift up on the Guard to
2
remove it.
3.
3
Repeat steps 1–2 to remove the Guard on the opposite side of the R40.
FOR REINSTALLATION, make sure to tighten the screws until they are snug.
2
2
3
"O"-RING
RETAINING TAB
3
11
Advertisement
Table of Contents
