Reassembling The Taker R40 After Charging; Power Pack Life; Operational Modes - Foxfury Lighting Solutions TAKER R40 Product Manual

REASSEMBLING THE R40 AFTER CHARGING
1. 1 Install the Power Pack to the Light Head—confirm position of alignment
posts to their respected cavities.
2. 2 Push both halves together. A 'click' should be heard as they become
locked together.
Test the light to make sure that the Power Pack is properly connected
to the Light Head by pressing the Power/Mode Switch.

POWER PACK LIFE

MODE
CONTINUOUS ON
TURBO-STROBE™
*Power Pack life may vary according to age and ambient conditions.

OPERATIONAL MODES

For CONTINUOUS ON mode: Press and hold the Power/Mode Switch
once.
For TURBO-STROBE™ mode: From CONTINUOUS ON mode, press the
Power/Mode Switch once.
For OFF or EXIT a mode: From TURBO-STROBE™ mode, press the
Power/Mode Switch once.
LOW POWER INDICATOR*: At a low level, the Charge Indicator will flash
for approximately 0.5–1.0 sec. It is suggested that you then charge or
replace the Power Pack with a fully charged one.
NOTE: Once the LOW POWER INDICATOR comes on, there is approximately
1–2 minutes of power remaining.
6
POWER PACK LIFE
1 hour
1.75 hours
LUMENS
650
650