Table of Contents
Advertisement
MAGNET ON VIBROACOUSTIC DAMPENING KIT "VIBROMAT"
Vibromat
Patient table
dock frame
anchor hole
1355
[53.3 in]
seismic anchor holes
673
4 x magnet
[26.5 in]
mounting holes
NOT TO SCALE
PATIENT TABLE DOCK ANCHOR MOUNTING REQUIREMENTS
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
BOLTED METHOD
FEMALE ANCHOR METHOD
(CUTAWAY SIDE VIEW)
(CUTAWAY SIDE VIEW)
9
The RF Shield vendor must design and install the dock anchor bolt
The dock anchor hole must be drilled after the Magnet is installed
The dock anchor must not contact floor rebar or other structural steel
The dock anchor must electrically contact the RF shield at point of entry
The RF shield vendor must perform a pull test on the anchor (equal to the clamping force).
NOT TO SCALE
Typical
390
[15.4 in]
Vibromat
673
[26.5 in]
VibroAcoustic Mat (M7000VA)
weight: 8 kg (each) [17 lbs]
1
Removable Anchor Rod (Male insert)
2
Dock
3
Clamp bracket
4
Finished floor
5
Filler Board or Grout
6
RF Shield
7
Conductive Fibrous Washer (RF seal)
8
Concrete
9
Female Anchor Insert
SIGNA PIONEER
MAGNET ROOM FLOOR SPECIFICATIONS
Floor must be flat and level to 3 mm [0.12in] between high and low spots over the area shown.
The finished floor must support the weight of all components (e.g., patient table, gradient coil replacement cart)
throughout operation and service life.
NOTE:
This drawing is to be used only as a design intent document. refer to ge installation manual for tray install.
actual tray installation may be site dependent.
This drawing not to scale
EN-MRI-TYP-SIGNA_PIONEER-WEB.DWG
3419mm
943mm
[134.61in]
[37.13in]
CABLE CONCEALMENT
200
[7.9 in
]
700
[27.6 in
Front of magnet
Customer/contractor installed
Magnet
cable concealment frame
geometric
customer/contractor to provide
isocenter
opening and install frame.
Rev
A
Date
23/Jul/2018
S3 - Structural Details
]
Cable trays
13
/24
Hide quick links:
Advertisement
Table of Contents
