Brocade Communications Systems VDX 6940 Hardware Installation Manual page 77

TABLE 9
LED name
System power (one LED
green)
System status (one bicolor
LED, green-amber)
Ethernet management port
status (one green LED)
Ethernet management port
link activity (one green
LED)
40 GbE port status in 40
GbE mode. Indicated by
first of four LEDs above or
below 40 GbE port.
Brocade VDX 6940 Hardware Installation Guide
53-1003495-02
Port-side LED patterns during operation
LED color
Off (no light)
Steady green
Off (no light)
Alternating amber and
green (Brocade VDX
6940-36Q)
Blinking green (Brocade
VDX 6940-144S)
Steady green
Blinking amber.
Off (no light)
Steady green
Off (no light)
Blinking green
Off (no light)
Steady green
Flashing green.
Status of hardware Recommended action
No power Verify the system is
powered on, the power
cables are attached, and
your power source is live.
Contact your service
provider.
Valid power. All monitored No action required.
voltages are nominal.
System is off or there is no Verify the system is on.
power.
A component requires Verify the component
attention. Most likely a status and check all
power supply or fan messages.
assembly has faulted.
System is on and No action required.
functioning properly.
A system fault has Check the management
occurred or the device is in interface and the error log
an initialization state. for details on the cause of
the status.
Contact your service
provider.
There is no link. No action required.
Link is present (1G link on No action required.
management port).
There is no activity. No action required.
There is activity (traffic). No action required.
No module or cable. The Install module or connect
40 GbE port is offline - cable.
either disabled, faulted, or
Enable the port.
enabled, but no link.
Check messages for faults
and take necessary action.
Establish link connection.
40 GbE port is online. Link No action required.
is present, but no activity.
Beaconing is enabled. No action required.
Operation
77