Brocade Communications Systems VDX 6940 Hardware Installation Manual page 57

FIGURE 33 Attaching the rear brackets to a rack
Attaching rear brackets to the switch
Complete the following steps to attach the rear brackets to the switch.
1. Align the right rear bracket to the right rear of the switch and use four 8-32 x 5/16-in. panhead screws
to attach the bracket to the switch as shown in
upper and lower slots in the bracket.
2. Align the left rear bracket to the left rear of the switch and use four 8-32 x 5/16-in. panhead screws to
attach the bracket to the switch. Again, use the upper and lower slots in the bracket.
3. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb. (17 cm-kg).
Brocade VDX 6940 Hardware Installation Guide
53-1003495-02
1. Retainer nuts, 10-32
2. Rear brackets
3. Screws, 10-32 x 5/8-in., panhead Phillips
Attaching rear brackets to the switch
Figure 34 . Be sure to insert the screws through the
57