Table of Contents
Advertisement
Installation procedure for flush-front mounting
Installation procedure for flush-front mounting
NOTE
The switch must be turned off and disconnected from the fabric during this procedure.
NOTE
The illustrations in this document show a 1U switch, but the instructions are the same for a 2U switch.
Complete these tasks to install the switch in a four-post rack:
•
Attaching the front brackets
•
Attaching the extension brackets to the switch
•
Installing the switch in the rack
•
Attaching the rear brackets to the extensions
•
Attaching the rear brackets to the rack posts
Attaching the front brackets
Complete the following steps to attach the front brackets to the switch.
1. Position the right front bracket with the flat side against the right side of the switch at the front of the
switch, as shown in
2. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket and
then into the holes on the side of the switch. Use the upper and lower screw holes, leaving the
center holes empty.
3. Repeat step 1 and step 2 to attach the left front bracket to the left side of the switch.
4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
42
on page 42
on page 43
on page 44
on page 45
on page 46
Figure 19
.
Brocade VDX 6940 Hardware Installation Guide
53-1003495-02
Advertisement
Table of Contents
