Installation; Gun Cable Adjustment - Graco LineLazer ES 1000 Operation - Repair - Parts

Installation

1. Install vertical gun mount onto gun bar.
NOTE: Make sure all hoses, cables, and wires are
properly routed through brackets.
3A4603C Operation, Repair, Parts

Gun Cable Adjustment

Adjusting the gun cable will increase or decrease the
gap between the trigger plate and the gun trigger. To
adjust trigger gap, perform the steps below.
1. Use wrench to loosen locking nut on cable adjuster.
ti30330a
2. Loosen or tighten adjuster until desired result is
achieved. NOTE: More thread exposed means less
gap between gun trigger and trigger plate.
3. Use wrench to tighten locking nut on the adjuster.
Gun Placement
ti27884a
19