Acyclic Data - Siemens Sitrans PROBE LU Instruction Manual

LCD
Cause/symptom (cont' d )
display
Factory calibration for the
S:34
device has been lost.
Factory calibration for the
S:35
device has been lost.
Factory calibration for the
S:36
device has been lost.
Ultrasonic module hard-
S:37 ware defect: Unable to col-
lect profile.
Ultrasonic module hard-
ware failure: unable to cal-
S:38
culate distance
measurement.
Transducer temperature
S:39
sensor failure.
Transducer temperature
S:40
too high.
Transducer temperature
S:41
too low.
Factory calibration for the
S:42 transducer temperature
sensor has been lost.

Acyclic Data

SITRANS Probe LU supports up to four simultaneous connections by a Class 2 Master
(C2 connection). It supports one connection by a Class 1 Master (C1 connection).
In order for a Class 1 Master to read parameters from an instrument, it needs to know the
slot and absolute index of the parameter.
The parameters are all listed in SIMATIC PDM under Help. If you do not have SIMATIC
PDM, you can download the DD and reference the HTML help file directly.
Page 32 SITRANS Probe LU (PROFIBUS PA) – INSTRUCTION MANUAL
Corrective Action (cont' d )
Repair required: contact your
local Siemens representative.
Repair required: contact your
local Siemens representative.
Repair required: contact your
local Siemens representative.
Repair required: contact your
local Siemens representative.
Repair required: contact your
local Siemens representative.
Reset power. If fault persists,
contact your local Siemens rep-
resentative: repair required.:.
Relocate device and/or lower
process temperature enough to
cool device. Inspect for heat-
related damage and contact
your local Siemens representa-
tive if repair is required.
Relocate device and/or raise
process temperature enough to
warm device. Inspect for dam-
age and contact your local Sie-
mens representative if repair is
required.
Repair required: contact your
local Siemens representative.
Byte Bit
2
3
4
5
4
6
7
0
5
1
2
7ML19985JB02