Wiring Examples; Edm Used And External Test In 24V Active Not Used; Reduced Wiring Connector Used And External Test In 24V Active Not Used - Omron F3SG-4RA****-25-02TS series Quick Installation Manual

Setting

5.Wiring Examples

For input/output circuit and other examples than below, refer to the user's manual.

5-1. EDM used and External Test in 24V Active not used

□□
F39-JD
KM1, KM2: Safety relay with forcibly guided contacts (G7SA)
M: 3-phase motor
*1. Connect the line to 24 V via a test switch (N.O. contact) if External Test is used.
*2. Connect a lockout reset switch (N.C. contact) to this line in series with the KM1 and KM2 if Lockout Reset is used.
□
*3. The F39-JD RA-L Single-Ended Cable for Emitter (Oil-Resistant Cable) does not have the red, white and yellow wires.
□ □
*4. For the F39-JD A- Single-Ended Cable, connect the shield line to 0 V.
5-2. Reduced Wiring Connector used and External Test in 24V Active not
used
The reduced wiring system can be achieved by using the Reduced Wiring Cables (F39-JD□BA) and the Reduced Wiring Connector
(F39-CN5).
F39-CN5
□
F39-JD B-L
KM1 KM2
*1. Connect the line to 24 V via a test switch (N.O. contact) if External Test is used.
□ □
*2. For the F39-JD A- Single-Ended Cable, connect the shield line to 0 V.
The F3SG-R meets IP67 (IEC 60529) when it is correctly connected with the Cable for Reduced Wiring (F39-JD
Reduced Wiring Connector (F39-CN5). Keep the F3SG-R from cutting oils when using these cables and connector.
□□□□
F3SG-4RA -25-02TS
Quick Installation Manual
Wiring
□□
A-L *4 F39-JD A-D *4
KM1 KM2
KM1
KM2
KM1
KM2
□
F39-JD A-D *2
KM1, KM2: Safety relay with forcibly guided contacts (G7SA)
M: 3-phase motor
+24 VDC
Power Supply
0 VDC
Mounting/Beam Alignment
[Settings]
Receiver EDM
External Test: 24 V Active (End Cap:
Emitter
Black) (factory default setting)
+24 VDC
Power Supply
0 VDC
[Settings]
External Test: 24 V Active (End Cap:
Emitter
Black) (factory default setting)
M
Operation check
Function
KM1
KM2
M
Function
□
BA) and
4