Table of Contents
Advertisement
TRIGGERING THE FLASH
1. With all devices turned off, connect
and secure the transmitter to
the camera by securing it to your
camera's hot-shoe mount.
2. Mount and secure the receiver
to your remote flash unit.
3. Turn on the camera, flash,
transmitter, and receiver.
4. Synchronize the channel selection
on the transmitter and receiver.
5. Press the flash test [
button on the transmitter or
receiver to verify flash firing.
22
]
6. With your camera set to the desired mode
and settings, half-press the shutter release
on the camera to autofocus the camera.
7. Fully press the shutter release on the
camera to activate the camera's shutter
and flash simultaneously. A green light
will appear on the transmitter when the
signal is sent, and a red light will appear on
the receiver when the signal is received.
Advertisement
Table of Contents
