Landoll 7450 VT Plus Operator's Manual page 63

RIGHT INNER WING
HOSE
CLAMP
BULKHEAD
PLATE
7450-reel-1
Figure 3-36: Mounting the Bulkhead Plates and
Fittings to the Wings
CENTER FRAME
GANG BAR
HOSE CLAMPS
7450-reel-2
Figure 3-37: Mounting the Gang Bar Hose Clamps
and Fittings
8. Install fittings into manifold according to Figures 3-26
RIGHT OUTER
WING
9. Install bulkhead plates to the inner and outer wings
10. Install fittings into 2-1/2" cylinders. All cylinders will
11. Install hoses per Figures 3-26 through 3-28. Hose
12. Install hose clamp brackets as shown at hinge lines
90 SWIVEL
ADAPTER
BULKHEAD
RUN TEE
RIGHT INNER
WING
90 SWIVEL
ADAPTER
13. Install other hose clamps as needed to secure
BULKHEAD
RUN TEE
NOTE
The outer two reels will need enough slack in the hoses
to go to the end of the stops when folded so allow some
extra hose next to the cylinder.
ASSEMBLY INSTRUCTIONS
through 3-28.
with hose clamps (3-36 and 3-37.) Assemble
bulkhead tees and 90º swivel adapters onto each of
them.
have a 90º fitting on the bottom side. The outer
cylinders on each side have a 45º fitting in the base
end and the others are a straight adapter.
routing to follow Figures 3-34 and 3-35.
with 1/2-13x1-1/2 round head square neck bolts and
nuts. Assemble hose clamp with 3/8-16 x 1-1/2 bolts
and 3/8 flange lock nuts (See Figure 3-38.)
GANG BAR
HOSE CLAMP
PLACEMENT
7450-reel-3
Figure 3-38: Gang Bar Hose Clamp Placement
hoses.
3-35