Operating Instructions - Kobalt KDD 524B-03 Manual

OPERATING INSTRUCTIONS

1. To Attach Battery Pack
a. Place the direction-of-rotation selector (C) in the
center (locked) position.
b. Align the raised portion on the battery pack with the
grooves on the bottom of the tool, then slide the
battery pack onto the tool, as shown.
c. Ensure that the battery-release buttons on the
battery pack snap into place and the battery pack is
secured to the tool before beginning operation.
NOTICE: When placing the battery pack on the tool, be
sure that the raised rib on the battery pack aligns with
the groove on the tool and the latches snap into place
properly. Improper assembly of the battery pack can
cause damage to internal components.
To Detach Battery Pack
a. Place the direction-of-rotation selector (C) in the
center (locked) position.
b. Press the battery-release buttons to release the
battery pack.
c. Pull forward on the battery pack to remove it from
the tool.
WARNING
• Battery tools are always in operating condition.
Therefore, the direction-of-rotation select or should
always be locked (center) when the tool is not in use or
when carrying the tool at your side.
2. Variable-Speed Trigger Switch
a. To turn the impact driver ON, depress the
variable-speed trigger switch (D).
b. To turn it OFF, release the variable-speed
trigger switch.
c. The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure.
Electric Brake
The impact driver is equipped with an electric
brake. When the variable-speed trigger switch
(D) is released, the electric brake engages
automatically to quickly stop rotation.
1a
C
1b
2
D
8
C
kobalttools.com