Table of Contents
Advertisement
Available languages
Available languages
OPERATING INSTRUCTIONS
1. To Attach Battery Pack
a. Align the raised portion on the battery pack
with the grooves on the bottom of the tool, then
slide the battery pack onto the tool, as shown.
b. Make sure that the latches on the battery pack
snap into place and the battery pack is secured
to the tool before beginning operation.
NOTICE: When placing the battery pack on the
tool, be sure that the raised rib on the battery pack
aligns with the groove on the tool and the latches
snap into place properly. Improper assembly of
the battery pack can cause damage to internal
components.
To Detach Battery Pack
a. Press the battery-release buttons to release the battery pack.
b. Pull backward on the battery pack to remove it from the tool.
WARNING
• Battery tools are always in operating condition. Therefore, always remove the battery pack
when the tool is not in use or when carrying the wrench at your side.
2. Direction-of-Rotation Selector
The direction of the anvil (A) rotation is reversible
and is controlled by the forward/ reverse selector
(B) located above the anvil.
a. Rotate the forward/reverse selector
counterclockwise for forward (clockwise)
rotation.
b. Rotate the forward/reverse selector clockwise
for reverse (counterclockwise) rotation.
c. Check the direction of rotation before every
use.
NOTE: To prevent damage, always allow the
wrench to come to a complete stop before changing
the direction of rotation.
1
2
9
Battery-Release
Buttons
Advertisement
Chapters
Table of Contents
