Canon UFR II User Manual page 54

7
In the [Printer Ports] dialog box, click [Close].
8
Click [Configure Port].
9
Set the port.
When using Raw
Select [Protocol] > [Raw] → click [OK].
When using LPR
(1) Select [Protocol] > [LPR] → specify one of the following print queues for [LPR Settings] > [Queue Name].
LP: Outputs according to the spool setting of the device. This is the setting that is normally used.
SPOOL: Always outputs after spooling to the hard disk, regardless of the device settings.
DIRECT: Always outputs without spooling to the hard disk, regardless of the device settings.
(2) Click [OK].
Changing Settings to Match the Usage Environment
50