Installation; Before You Begin; Enclosure Options; Beginning The Installation - Radionics D7212 Operation And Installation Manual

Before You Begin

This Installation section contains a general installation procedure. It refers you to other
sections of the manual for detailed instructions.
Radionics recommends you review this manual and the D7212 Program Entry Guide
(74-06915-000) before you begin the installation to determine the hardware and wiring
requirements for the features you want to use.
Have the following additional documents handy as you read through this manual:
•
•
•
Before you begin the installation of the D7212 you should be familiar with the operation of
the D5200 programmer or the RAM II remote programmer.

Enclosure Options

Mount the D7212 Control/Communicator assembly in any of the Radionics enclosures
listed below. Refer to the Installation Guide for UL and Fire Applications in this manual to
determine if your application requires a specific enclosure.

Beginning the Installation

Mounting the Enclosure

Mount the enclosure in the desired location. Be certain to use all five mounting holes. See
Figure 2.
POINT CHART LABEL
74-06913-000-B 2/96

Installation

D7212 Program Record Training Sheet (74-06895-000)
Security System Owner's Manual (71-06633-000)
D7212 Operation and Installation Manual (74-06144-000)
• D8103 Universal Enclosure (gray)
• D8109 Fire Enclosure (red)
• D8108A Attack Resistant Enclosure (gray)
MODULE MOUNTING
MOUNTING
SKIRT HOOK
SKIRT MOUNTING HOLE
Figure 2: Mounting Enclosure
D7212 Operation & Installation Manual
LOCATIONS
TAMPER SWITCH
MOUNTING LOCATION
Page 13
MOUNTING
SKIRT HOOK
HOOK OPENINGS
BACK OF D7212
MODULE
MOUNTING
LOCATIONS
LOCK-DOWN TAB
© 1993-1996 Radionics