Uplift Desk CPU001 Instructions

Package contents

Screws
(qty 4)
fig 1.
UPLIFT Desk • 1-800-349-3839 • info@upliftdesk.com • www.upliftdesk.com
Washers
(qty 4)

*Consider placement:

Decide if you want the CPU Holder mounted to the front or side of your
desktop. Once installed, the CPU Holder will remain in this location and
will swivel 180° to allow you access to your CPU's ports. Take a moment
to find a place underneath your desk where you won't have any ob-
structions when rotating the CPU Holder.

Step 1

Hold the Mounting bracket under your desk at the location you've
chosen, and mark the location of the four screw holes on your desktop.

Step 2

Using a drill with a 1/8" bit, drill pilot holes where the four marks are
located. Drill no deeper than 1/2''.
CAUTION: Do not drill through the desktop surface. Make sure
screws aren't too long for your desktop thickness by holding the
screw up to the desktop's edge. When using screws on a desktop
with a center-cut ergo edge, make sure that the screw is not close to
the ergo edge to avoid piercing the desktop with the screw. (see fig. 1)

Step 3

Install the Mounting bracket with the four (4) Screws and four
(4) Washers.

Step 4

(a)
(a) Loosen the two knobs on the right and left side to adjust the height
of the Main unit to accommodate your CPU.
(b) Unlatch the four (4) Lock levers to adjust the width of the Main unit
to fit your CPU.
Note: If any of the Lock levers are too tight to open, you
can loosen them slightly with a 2.5mm Allen wrench (not
included). Once you release the Lock levers, you can rotate
(b)
them counterclockwise to loosen them.
Next, expand the Main unit to its widest/tallest position.
®
E3 CPU Holder
CPU001
Mounting bracket Main Unit
CPU128/R01