Base Vesa mount (x1) Vesa mount (x1) Base Lower arm 3mm Allen wrench 4mm Allen wrench 6mm Allen wrenc Safety and Warnings CAUTION: Read all instructions before assembly. Failure to assemble or operate properly may result in damage or personal injury. Retain manual for future reference. Lower Clamp Upper Clamp Upper Clamp...
Page 4
.25” Step 4 (Clamp Method) A. Use the 4mm Allen Wrench to adjust the four pre- 0.25” 0.25” installed screws on the back of the Lower Clamp so that there are about 0.25” of thread between the plate and screw heads. B.
Page 6
Step 11 A. Slide the Upper Arm into the hole on the Lower Arm until it is fully seated B. Tighten the set screw on the Lower Arm with the flat-head end of the provided 3mm Allen Wrench (or a small flat head screwdriver). This will prevent the Upper Arm from becoming separated from the Lower Arm during adjustment.
Step 17 A. If you have selected the Clamp Method, you can now snap the Wire Cover onto the back of the Upper Clamp as shown and insert your monitor cables through the two integrated clips. B. The Wire Cover adds 0.8” to the back of the Clamp assembly.