Connecting To Your Router; Connecting The Service - Polycom 650 User Manual

•
To connect to the base stand, line up the protrusions on the stand with the holes on the back
of the module. Snap into place.

Connecting to your router

Before connecting the service, make sure your router is set up to perform NAT (Network Address
Translation) and act as a DHCP server - normally a default setting on most routers (a fixed IP
address is not supported).
Next, plug the Ethernet cable from the phone into your router. Once powered up, an IP address
should automatically be allocated to the phone through DHCP. It's also important to ensure the
following ports are not blocked by the firewall within your router or at any point through your access
provider.
80 TCP
443 TCP
53 UDP
123 UDP
If these ports are not opened - i.e. a network based or your company firewall is blocking
them - Horizon will not work.
Access to the Horizon platform needs unrestricted phone access to the following Internet Protocols,
based within the network. The initial remote access request from the handsets, once plugged in,
will be to resolve one of the below URLs:
Soundpoint 335
Soundpoint 450
Soundpoint 650
Soundpoint 335
All these URLs will resolve to one of the following IP addresses:
•
Provisioning IP's = 88.215.61.171 & 173, 88.215.61.193 & 194 -
•
The Access SBC (general call traffic), ntp.business-access.co.uk (88.215.61.81 or 82)

Connecting the Service

To complete the connection process, you'll now need to:
•
Plug the computer cable into a spare port on your router or switch.
•
Connect the power supply unit into the nearest socket if not using PoE. The phone will power
up and your phone number will appear on the display.
Polycom 650 IP Phone User Guide V1.0
10000 to 60000 UDP
ICMP
SIP ALG disabled
5060 &5062 TCP/UDP
http://xsp.unlimitedhorizon.co.uk:80/dms/Polycom_335/
http://xsp.unlimitedhorizon.co.uk:80/dms/Polycom_450d/
http://xsp.unlimitedhorizon.co.uk:80/dms/Polycom_650d/
http://xsp.unlimitedhorizon.co.uk:80/dms/Polycom_335/