Times]; Sec] - Panasonic AMK3000P22 Installation Manual

No. Function name
Sleep Operation
P356
Delay Time
Speed Search
P357 Selection during
Startup
Standby Time for
P359
Speed Search
Recover Time for
P360 Speed Search
Voltage
Speed Search
P361 Selection during
Retry
Speed Search Retry
P362
Selection
Speed Search Retry
P363
Times
Upper Frequency
P364 Limit Selection for
Speed Search
*1) When a fault trip occurs, reset cannot be made with stop signal input from external
devices.
Therefore, use STOP SW on the panel to reset the fault trip.
But if the reset lock function is used, it will take precedence. In addition, reset
fuction is also valid.
*2) When the set value displayed with "r", it indicates the contact b output.
(If "r" is not displayed, it indicates contact a output. )
*3) When the set value displayed with "r", ON indicates non-exciting operation.
(If "r" is not displayed, ON indicates exciting operation. )
*4) Initial value varies with inverter capacity.
*5) Initial value varies with applicable input voltage of inverter.
It is 200 for 200 V voltage and 380 for 400 V voltage.
P057: It is 275.0 for 200 V voltage and 550.0 for 400 V voltage.
P205, P218: It is 200 for 200 V voltage and 380 for 400 V voltage.
*6) It is valid during power OFF. (The changed parameter value is valid when the
power is turned ON from OFF.)
*7) The change from manual torque boost to auto torque boost or vice versa cannot be
made during operation.
*8) For 5.5kW to 15kW, the setting range is 0.000 to 65.00, the setting unit is 0.001[Ω],
please pay attention to the setting and response of communication function.
*9) When the setting range is 0.04 to 99.99, the setting unit is 0.01; when the setting
range is 100.0 or above, the setting unit is 0.1; when the setting range is 1000 or
above, the setting unit is 1.
Changes
during RUN
0.0 to 25.0
○
0: Invalid
○
1: Valid
0.0 to 100.0
○
0.0 to 10.0
○
0: Invalid
○
1: Valid
0: Stop by error
○
1: Operation with starting frequency
0 to 10
○
0: Lower than the maximum frequency
1: Lower than the previous frequency
○
before operation coasts to stop.
Setting range
Initial
Unit
value

0.1[sec]

0.0
0
－
0.1[sec] 0.5
0.1[sec] 0.5
0
－
0
－

1[times]

0
0
－
56