Quantum StorNext QD7000 Upgrade Manual page 36

28 |
• The Display Name does not reflect the change from LSI to NetApp. This might occur because the
display name became free test after initial discovery. In this case, you can change the Display
Name manually.
If dead paths appear, perform the following steps.
Steps
1. Perform a rescan on the each host.
2. Halt all host I/O operations to this subsystem.
3. To reclaim the volumes under NetApp rule, perform the following steps.
a. From the command line, run the
the output from the command to identify volumes whose names have the form
b. From the command line, run the command
reclaim -d naa.xxxxx
esxcli storage core device list
do esxcli storage core claiming
to change the LSI vendor ID to NetApp.
command. Check
.
aa.xxxx