Attaching The Screw Lock Terminal Block - Pro-face GP-2401T User Manual

Chapter 3 - Installation and Wiring
3.5

Attaching the Screw Lock Terminal Block

Using the AUX Input/Output I/F requires the separately sold Screw Lock Terminal
Block. Use the procedures shown below to attach the Screw Lock Terminal Block
to your GP unit's AUX I/O I/F.
(The illustrations below show the procedures for the GP-2501T/GP-2501S/GP-
2601T models. However, these procedures are also the same for the GP-2401T.)
3-14
1) Loosen the set screws of each de-
sired Screw Lock Terminal Block
pin.
2) Insert each wire end into its pin and
tighten the set screw.
3) Re-insert the Terminal Block into the
AUX I/O I/F.
4) Raise both of the Terminal Block's
right and left side clamp levers to
secure the Terminal Block to the
AUX I/O I/F.
GP-2401/2501/2601 Series User Manual