Structural - Pro-face GP-2401T User Manual

2.1.3 Structural

Grounding
*1
Ratings
(For front panel of
installed unit)
Weight
Cooling Method
External
3.
Dimensions
*1 The front face of the GP unit, installed in a solid panel, has been tested using condi-
tions equivalent to the standards shown in the specification. Even though the GP
unit's level of resistance is equivalent to these standards, oils that should have no
effect on the GP can possibly harm the unit. This can occur in areas where either
vaporized oils are present, or where low viscosity cutting oils are allowed to adhere
to the unit for long periods of time. If the GP's front face protection sheet becomes
peeled off, these conditions can lead to the ingress of oil into the GP and separate
protection measures are suggested. Also, if non-approved oils are present, it may
cause deformation or corrosion of the front panel's plastic cover. Therefore, prior to
installing the GP be sure to confirm the type of conditions that will be present in the
GP's operating environment. If the installation gasket is used for a long period of
time, or if the unit and its gasket are removed from the panel, the original level of the
protection cannot be guaranteed. To maintain the original protection level, you need
to replace the installation gasket regularly.
GP-2401/2501/2601 Series User Manual
GP-2401T
100 Ω or less, or your country's applicable standard
1.7 kg (5.5lb) or less
W215mm [8.46in]
x H170mm [6.69in]
x D60mm [2.36in]
Chapter 2 - Specifications
GP-2501T GP-2501S
Equivalent to IP65f (JEM 1030)
NEMA#250 Type4X/12
3.5kg (7.7lb) or less
Natural air circulation
W317mm [12.48in]
x H243mm [9.57in]
x D58mm [2.28in]
GP-2601T
2-3