Orientalmotor OPX-2A Operating Manual page 16

6 Monitor mode
• How to reset an alarm
Be sure to remove the cause of the alarm, and then reset the alarm by following the steps below:
1.
While an alarm is displayed, press the
2.
Press the
3.
Press the
The alarm is reset.
Overcurrent and EEPROM error alarms cannot be reset on the OPX-2A. To reset
Note
these alarms, you must cycle the power (p.40).
• How to check an alarm record
You can check up to ten most recent alarms, starting from the latest one.
1.
While an alarm is displayed, press the
The latest alarm is displayed.
2.
Press the
The second latest alarm is displayed.
3.
Every time the
• How to clear all alarm records
You can clear all alarm records at once.
1.
While an alarm is displayed, press the
2.
Press the
3.
Press the
All alarm records are cleared.
Present alarm
−16−
key twice to select the alarm reset screen.
key.
key.
key is pressed, the next older alarm will be displayed. Use the
keys to select the alarm record you want to check.
key and select the alarm record clear screen.
key.
Alarm record 1 (latest)
Alarm record 2
Alarm record 10 (oldest)
Alarm reset
Clear alarm records
Alarm record 1 (latest)
∗ If operations are limited by the edit lock function (p.7), the screen text in gray is not shown.
key to move to the lower level.
key to move to the lower level.
key to move to the lower level.
Use
to navigate
through the items.
Alarm is being reset (blinking display)
Alarm records are being
cleared (blinking display)