Download Data; Download Folder Path - ION GASCLAM 2 Software Manual

GasClam 2 Software Manual Ion Science Ltd.
Sampling
When sampling starts the status text
changes to "Sampling".
During sampling all the readings on the
right-hand side progressively change
from "Sampling" to a value, starting with
the pressures then the temperature and
then the sensors.
This takes approximately 2 minutes.
Note: The voltage of the battery will
slightly decrease when the GasClam 2 is
sampling due to a higher load on the
batteries.
Logging Mode
When sampling is complete the status
text changes to "Logging Mode" and the
"Sample Count" increases by one.
All the previous readings are visible in
the "Last Reading Stored" box.
If any errors occur they will appear in the
Error Notification Box.
After the logging interval "Sampling" will
start again.
Important: Before deploying the GasClam 2 in a borehole it is highly recommended to perform at least one
sample to check that the readings are correct.

6. Download Data

6.1. Download Folder Path

To download logging data from the GasClam 2 first stop logging by
either using the Start Button Cable (see User Manual) or the software
start/stop button in the "Home" window.
Click the "Download Data" button. A popup window will ask you for the
path to your download folder, either select an existing folder or "Make
New Folder" in the selected location e.g.:
My Documents\GasClam 2\Downloads
The software will remember your last chosen path but will ask you each
time. Click "OK" to continue.
Unrivalled Detection. ionscience.com