Software Start/Stop; Logging Cycle - ION GASCLAM 2 Software Manual

GasClam 2 Software Manual

5.2. Software Start/Stop

When the GasClam 2 is in "Sleep Mode", start logging by clicking the
green "Start" button.
A few questions will be asked before logging actual starts:
•
Moisture filter state (see User Manual), "Yes" if the filter is
OK will continue.
"No" will abort the logging start.
•
If the GasClam 2 date and time is not the same as the PC date
and time you will be prompted if this is ok.
"Yes" will update the GasClam 2 time and continue.
"No" will not update the time but also continue.
•
If the GasClam 2 already contains some logging data you will
be asked if you want to erase it before continuing.
"Yes" will erase the data and start logging.
"No" will not erase the data but will also start logging.
"Cancel" will abort the logging start.
The GasClam 2 will then immediately start the first sample, this takes
approximately 2 minutes. Progress is shown in the green bar.
Logging can be stopped at any time by clicking the red "Stop" button.
You will then be prompted to confirm the action.

5.3. Logging Cycle

Sleep Mode
When the GasClam 2 is in "Sleep Mode"
all the buttons are available and the
start/stop button is green ready to start
logging when clicked.
The "Sample Count" shows the total
number of records in the memory. Once
logging has started the sample count will
show how many samples have been
completed.
Unrivalled Detection. ionscience.com
Ion Science Ltd.