Table of Contents
Advertisement
6. Using the TigerPC Software and Downloading Data
The TigerPC software enables you to fully configure the instrument, view and edit gas tables, and
view logged data, including health and safety readings.
PC Requirements
TigerPC Software must be used in conjunction with a PC or laptop using Windows 10.
Installation of TigerPC Software
Download the TigerPC software from the ION Science website:
http://www.ionscience.com/customer-support/media-centre/instrument-software/
Run setup.exe to install the software.
Alternatively, the TigerPC software can be purchased on a memory stick.
Follow the prompts until the installation is complete. Should you have difficulty, please contact your
local distributor, or contact ION Science directly:
http://ion-science-2016.gridglobal.co.uk/contact/
Connecting a TIGER to a PC
The TIGER must be functionally checked prior to entering a hazardous area after
every occasion when a connection has been made to the USB port. The
instrument must complete its start-up routine and display legible readings. If the
LCD display fails to show an intelligible and uncorrupted display the instrument
must not enter a hazardous area.
Connect your TIGER to the PC. The (type B) USB port of the TIGER is located at the back of the
instrument, above the charging connectors. A flap on the Instrument Boot can be opened to reveal
it.
While the TIGER is connected, the instrument will go into Sleep Mode
instrument will "awaken" when it is disconnected.
Unrivalled Gas
Detection.
TIGER Instrument User Manual V3.10
if set to do so in
Page 24 of 72
TigerPC. The
ionscience.com
Advertisement
Table of Contents
