ION GASCLAM 2 Software Manual page 21

7.2.2. Start-Stop Data Tab
The "Start-Stop Data" tab shows when logging was started with a note regarding the logging interval.
The tab also shows when and how logging was stopped with a note regarding the total number of
samples taken during that run. If a single run is shown and there were no errors then just two rows
are shown.
If the data is from a combined file more start and stop rows will be visible and also if any logging runs
were halted by errors, such as "Low Battery", then this information is also shown.
7.2.3. Error Message Tab
All errors can be view in one location in the "Error Messages" tab. This is useful information to
evaluate actual battery life if there are "Low Battery" errors and to consider shorter intervals
between site visits.
An important error is the "Immersion" error which indicates that the GasClam 2 has been flooded
(see User Manual for service details).
The "Filter" and "Pump" errors indicate that the filter needs replacing. For a full list of errors and
solutions see the Error section.
Unrivalled Detection. ionscience.com