Checking Accessories; Fcc Notice; Warnings; Caution - Remotec ZTS-110 User Manual

Z-Wave device type
Basic Device Class: Routing_Slave
Generic Device Class: Thermostat
Specific Device Class: Thermostat general v2
Z-Wave Command Class
COMMAND_CLASS_THERMOSTAT_FAN_MODE
COMMAND_CLASS_THERMOSTAT_FAN_STATE
COMMAND_CLASS_THERMOSTAT_MODE
COMMAND_CLASS_THERMOSTAT_SETPOINT
COMMAND_CLASS_THERMOSTAT_OPERATING_STATE
COMMAND_CLASS_THERMOSTAT_SETBACK
COMMAND_CLASS_SENSOR_MULTILEVEL
COMMAND_CLASS_CLOCK
COMMAND_CLASS_BATTERY
COMMAND_CLASS_BASIC
COMMAND_CLASS_VERSION
COMMAND_CLASS_MANUFACTURER_SPECIFIC
COMMAND_CLASS_ASSOCIATION
COMMAND_CLASS_CONFIGURATION

Checking Accessories

After opening the cover of the packaging box, check that the following accessories
are included.
- ZTS-110: Z-Thermostat
- Screw + Wall Anchor x 4pcs
- RC/RH jumper wire x 1pc
- User Manual
37

FCC Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Controlled Supported
NOTE:
This equipment has been tested and found to comply with the limits for a Class B
NO YES
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
NO YES
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
NO YES
energy and, if not installed and used in accordance with the instructions, may cause
NO YES
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
NO YES
harmful interference to radio or television reception, which can be determined by
NO YES turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
NO YES
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
NO YES
- Connect the equipment into an outlet on a circuit different from that to which the
NO YES
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
YES YES
Notice : Changes or modifications to this unit not expressly approved by the party
NO YES
responsible for compliance could void the user authority to operate the equipment.
NO YES

Warnings

NO YES
- Do not modify the unit in any way.
NO YES
- Risk of fire.
- Risk of electrical shock.
- Risk of burns.
- Do not dispose of electrical appliances and unsorted municipal waste, use
separate collection facilities. Contact your local government for information
regarding the collection systems available.
- There is no user serviceable parts in this unit.

Caution

- Risk of explosion if battery is replaced by an incorrect type.
- Dispose of used batteries according to the instructions.
38