Remotec ZTS-110 User Manual page 15

Z-Wave Add (Include) / Delete (Exclude) into/from Z-Wave network
Add (Include) ZTS-110 to Gateway / Controller Z-Wave
network
Symbol Inclusion and Exclusion Mode Key Description
Add (Include) / Delete (Exclude)
Step Procedure / Description
Gateway / Controller device should be set
to inclusion mode.
Press and hold "Home" key for 2 seconds
1
to set ZTS-110 to Add (Inclusion) / Delete
(Exclusion) Mode.
Press "Prog" key once, it will search the
2
network.
If the ZTS-110 is added into the network
3 successfully, the signal of "done" will
appear.
Press "Home" key once to go back to the
home page.
4
will appear on the main display.
27
Note:
- It is recommended to perform the Delete/Exclude procedure before doing
Add/Include. This is to make sure the ZTS-110 is not in any other Z-Wave
network which will result in failure in Inclusion process.
- If the inclusion is failed, try exclusion, and/or reset ZTS-110 to factory default and
try inclusion again.
- After ZTS-110 is included to Z-Wave network, it will stay in Easy mode by default.
- You can enable or disable Easy mode by local "Setting Mode" or Z-Wave
parameter number 8.
(please refer to parameter table at Z-Wave Configuration Parameters).
LCD indication
Delete (Exclude) ZTS-110 from Gateway / Controller Z-Wave
network
Step
1
2
MO WAKE
AM
PROG ON
COOL
3
FAN AUTO
4
Procedure / Description
Gateway / Controller device should be set to
Exclusion mode.
Press and hold "Home" key for 2 seconds
to set ZTS-110 to Add (Inclusion) / Delete
(Exclusion) Mode.
Press "Prog" key once, it will search the
network.
If the ZTS-110 is removed from the network,
it shows no connection. Exclusion is
completed.
MO
Press "Home" key once to go back to the
home page.
PROG ON
will appear on the main display.
28
LCD indication
WAKE
AM
OFF
FAN AUTO