Mfa Hardware Instructions; Internal Components - GE Mini Field Agent User Manual

2 MFA Hardware Instructions

2.1 Internal Components

Caution
The MFA module is shipped with a battery pre-installed. The battery holder is located below the Supercap, and can be
replaced by opening the top cover.
To replace the battery
1. Power OFF the MFA Module.
2. Wait for 1 minute.
3. Open the top cover by loosening the four screws on the edges.
4. Use a small flat-head screw driver to gently pry out the old battery.
5. Insert the new battery.
Warning
The MFA module has an optional cellular modem. The SIM is available as a pre-installed option or may be installed by the
customer. The SIM card holder is located underneath the cellular modem and can be installed by opening the top cover and
removing the cellular modem.
To install a SIM Card
1. Power OFF the MFA Module.
2. Wait for 1 minute.
3. Open the top cover by loosening the four screws on the edges.
4. Remove the cellular modem by removing the two screws, tilt the modem up and slide out of the connector.
5. Slide the SIM card holder latch toward the Open position and flip it open.
6. Slide the SIM card into the holder so that the contacts will face down when closed and with the notched end extending out
of the holder.
7. Close the SIM card holder and slide the latch to the Locked position.
For public disclosure
The only user-serviceable components in the Mini Field Agent are the Real Time Clock
Battery and cellular SIM card. Do not remove or alter any other components on the Mini
Field Agent.
Replace battery only with Rayovac BR2032 or part IC690ACC001B or later. Use of
another battery may present a risk of fire or explosion.
Battery may explode if mistreated. Do not recharge, disassemble, heat above 100 °C
(212 °F) or incinerate.
GFK-2993F 16