Table of Contents
Advertisement
Operation and Control
• Carefully position the wet concrete cutter / chaser on the surface to be machined.
• The surface is machined with circular or linear movements, while the wet concrete
cutter / chaser is guided over the surface to be machined with only a moderate pres-
sure.
Cutting / chasing along a wall and near a corner
Figure 9
The handle (1) can be folded up for cutting or chasing near corners (see Figure 1,
page 15).
End the cutting / chasing work
• Danger!
Risk of injury due to continued running of the grinding disc after the concrete cutter /
chaser has been switched off.
► Always hold the grinding disc away from your body and wait for it to completely
stop before putting down the wet concrete cutter / chaser.
The wet concrete cutter / chaser switches off as soon as the ON / OFF switch (2) is
released (Figure 8, page 18). Do not put down the wet concrete cutter / chaser until
the grinding disc has stopped.
After wet cutting / chasing:
• Turn off the water supply. Uncouple the machine from the supply hose. Completely
open the tap (3) and allow the water to completely discharge (Figure 7, page 18).
(Figure 7 and Figure 8, page 18)
(Figure 9)
19
Advertisement
Table of Contents
